If you have an access list which uses the log parameter then where you can see the log depends on how you have configured logging (both destination and severity level). If you configure the logging severity level at informational (level 6) or debugging (level 7) you should see the access list logging but if you configure the severity level at anything above these levels then the access list logging will not be included. If you have enabled logging to the console (which is enabled by default on most platforms) at an appropriate level the access list log messages would be displayed on the console. If you have enabled logging buffered at an appropriate level then you can display the log messages by using the show log command. If you have enabled logging monitor at an appropriate level and have entered the terminal monitor command then the access list log messages will be displayed in your remote session. If you have enabled logging host (to a syslog server) at an appropriate level then the access list log messages are sent to the syslog server and you can see them on the server using appropriate tools and commands on the server.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.