Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

how can i make static network with SF302-08P

Hi, I'm in trouble with SF302-08P again.

 

I want to make static network with 4 SF302. I changed  1 SF302-08P as L3 mode and was supposed to use 3 SF302-08P as L2.

 

although changed the switch as L3, it didn't support dynamic routing but only static routing.

it means there was no "ip routing" command. i really need the command but there wasn't  in my switch.

 

pl check the attached image and packet tracer file what i imagined.

in the file, the switches i used will not be used, as i mentioned.

 

how can i make communication between Host and Host in static routing without "ip routing" command?

2 REPLIES
Silver

Hi again :), You should be

Hi again :),

 

You should be fine with static routing, just make sure that the routing is enabled.


Can I ask you for the output of the following command?

show ip route

It should contain a line like this:

IP Forwarding: enabled

 

If that's the case, IP routing is enabled and you should be good to go. Routing between the SVI's should be fine and so should be the communication between the hosts. Just make sure that the hosts are currently configured and all SVIs on the L3 Switch are up and active, working properly. Then, any packet from host from let's say vlan301 should be able to communicate with other hosts from vlan302 and vlan303.

Maybe your IOS doesn't support that feature, but according to the documentation it should. Though I'm not 100% sure.

Best regards,
Jan

 

New Member

hi, good to see u again, too.

hi, good to see u again, too.

 

when i wrote the command in L3 switch, it showed

BB1(config)#do sh ip route
Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP
       D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
       N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
       E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP
       i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area
       * - candidate default, U - per-user static route, o - ODR
       P - periodic downloaded static route

Gateway of last resort is not set

C    192.168.101.0/24 is directly connected, Vlan301
C    192.168.102.0/24 is directly connected, Vlan302
C    192.168.103.0/24 is directly connected, Vlan303
 

there is no the state, also SVIs are up on L3 switch.

 

well, i think the attachment 'll show u what i want to say, if u have packet tracer.

in the program, it's possible to communication between host(Vlan) and L3.

but the L3 switch can't send a message from vlan 301 to anywhere.

 

even though u'r not 100 sure, the one who i depend on is only u, i feel  aways thank u, jan.

136
Views
5
Helpful
2
Replies