Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

How can i route between ip and ipx network in 6500 switch?

How can i route between ip and ipx network in 6500 switch ?

1 REPLY

Re: How can i route between ip and ipx network in 6500 switch?

If you mean translating IPX to TCP/IP I don't think you can do that since the protocols are so different.

What you can do is dual stack the network with both IPX and IP - so each device gets an IP and IPX address - and route both IPX and IP on your Catalyst 6500.

This will allow devices that still require IPX to use IPX within the LAN and use IP for internet access and everything else.

To configure IPX on a VLAN in the Catalyst 6500:

ipx routing

int vlan 30

description Network 1

ip address 192.168.100.1 255.255.255.0

ipx encapsulation ARPA

ipx network A53

153
Views
0
Helpful
1
Replies
CreatePlease to create content