Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

How do do port channels on a 3750 stack?

I have a couple of 3750 stacks.

I am trunking them together (I am runnign BGP on each of them with seperate providers and AS numbers...)

I am trying to set up some redundancy int he trunks so should one of the 3750s fail, the trunk will remain up.  I tried to set up a port channel group (L2 Ether Channel) across the two blades (one port on 3750 A and one on 3750 B), but that seems to be illegal.

Does anybody know how I can configure a L2 port channel across a 3750 stack?  Or something similar that achieves redundancy?

thanks

Joerg

2 REPLIES
Hall of Fame Super Blue

Re: How do do port channels on a 3750 stack?

Joerg

Have you used this doc as a config guide -

3750 cross stack ethercherchannel

Jon

Re: How do do port channels on a 3750 stack?

I have a couple of 3750 stacks.

I am trunking them together (I am runnign BGP on each of them with seperate providers and AS numbers...)

I am trying to set up some redundancy int he trunks so should one of the 3750s fail, the trunk will remain up.  I tried to set up a port channel group (L2 Ether Channel) across the two blades (one port on 3750 A and one on 3750 B), but that seems to be illegal.

Does anybody know how I can configure a L2 port channel across a 3750 stack?  Or something similar that achieves redundancy?

thanks

Joerg

Hi Joerg,

Check out the below link also with sample example and configuration of etherchannel in 3750 switches.

http://docs.google.com/viewer?a=v&q=cache:SDcW6L7vPgYJ:https://www.cisco.com/application/pdf/paws/69979/cross_stack_etherchannel.pdf+sample+etherchannel+configuration+3750+stack&hl=en&gl=in&pid=bl&srcid=ADGEESi375x_AXG01ePZBL-54nmxS7HOMs5LgkjUpQXGfl-...

Hope to Help !!

Ganesh.H

Remember to rate the helpful post

4053
Views
0
Helpful
2
Replies
CreatePlease to create content