How do I configure bonding 3 T1s between a Cisco 6500 and a Cisco 2811 to make a 4.5Mg link between the 2 routers?

[valraeverbois]

I have a Cisco 6500 router at my POP site and  I have a Cisco 2811 at the tail site.  I have to bond 3 city to city T1s to make a 4.5Mg pipe between the 2 ends.  How do I configure the routers to make this happen?  This is a configuration example for a single T1:

POP end on 6500:

interface Serial1/0/1:0

ip address 10.125.1.1 255.255.255.248

Tail site on 2811:

interface Serial0/2/0

ip address 10.125.1.6 255.255.255.248

[andrew.prince · Accepted solution]

Use your favorite search engine for "PPP Multilink"

[valraeverbois]

Thanks so much. I have completed the configs.

Valeria Verbois

Dept.of Children and Family Services

IT Tech Support Spec.2

Phone: 225-342-0121

Fax: 225-342-2581

email: valeria.verbois@la.gov

[andrew.prince]

You are very welcome. Glad to help.