Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

How do I configure bonding 3 T1s between a Cisco 6500 and a Cisco 2811 to make a 4.5Mg link between the 2 routers?

I have a Cisco 6500 router at my POP site and  I have a Cisco 2811 at the tail site.  I have to bond 3 city to city T1s to make a 4.5Mg pipe between the 2 ends.  How do I configure the routers to make this happen?  This is a configuration example for a single T1:

POP end on 6500:

interface Serial1/0/1:0

ip address 10.125.1.1 255.255.255.248

Tail site on 2811:

interface Serial0/2/0

ip address 10.125.1.6 255.255.255.248

1 ACCEPTED SOLUTION

Accepted Solutions

How do I configure bonding 3 T1s between a Cisco 6500 and a Cisc

Use your favorite search engine for "PPP Multilink"

3 REPLIES

How do I configure bonding 3 T1s between a Cisco 6500 and a Cisc

Use your favorite search engine for "PPP Multilink"

New Member

Re: How do I configure bonding 3 T1s between a Cisco 6500 and a

Thanks so much. I have completed the configs.

Valeria Verbois

Dept.of Children and Family Services

IT Tech Support Spec.2

Phone: 225-342-0121

Fax: 225-342-2581

email: valeria.verbois@la.gov

Re: How do I configure bonding 3 T1s between a Cisco 6500 and a

You are very welcome. Glad to help.

284
Views
0
Helpful
3
Replies