Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How do I configure port bandwidth limitation on Cisco 2950 24 port?

I would like to limit the user bandwidth once it enter the switch. For exmaple, limit the bandwidth to 512Kbit/s.Shld I use port-limit or policy-map? My software version is 12.1(22)EA13.Thanks for helping out!

2 REPLIES
Bronze

Re: How do I configure port bandwidth limitation on Cisco 2950 2

As your code supports both, you can use either 'port based traffic control-Storm Control' or you can police rate using QoS.

If your purpose is just limited to restrict bandwidth then first option is much easier to configure on per interface basis whereas by using second method you can mark violating traffic. This can be helpful if you want end to end QoS.

Refer this if you need configuration help:

http://www.cisco.com/en/US/docs/switches/lan/catalyst2950/software/release/12.1_22_ea11x/configuration/guide/swtrafc.html#wp1063295

http://www.cisco.com/en/US/docs/switches/lan/catalyst2950/software/release/12.1_22_ea11x/configuration/guide/swqos.html#wp1045516

New Member

Re: How do I configure port bandwidth limitation on Cisco 2950 2

Hi, it seems like my switch can input the policy-map command.

483
Views
0
Helpful
2
Replies