07-25-2014 12:18 PM - edited 03-07-2019 08:11 PM
I have a Cisco SG200-26. I'd like to connect a system running Wireshark to this and be able to see traffic. In other switches I would have to configure this port as promiscuous or set this port to monitor other ports or in some way allow this port to see traffic destined for other ports. How do I do this on a SG200-26? I can't find any reference in the documentation nor was I able to turn up anything in a search here.
Thanks,
Dave
Solved! Go to Solution.
07-27-2014 07:28 AM
Hi Dave
http://www.cisco.com/c/dam/en/us/td/docs/switches/lan/csbss/sf20x_sg20x/administration_guide/78-21139.pdf
Have a look at chapter 7 page 77
Hope this helps
Regards Alex
Please rate useful posts
07-27-2014 07:28 AM
Hi Dave
http://www.cisco.com/c/dam/en/us/td/docs/switches/lan/csbss/sf20x_sg20x/administration_guide/78-21139.pdf
Have a look at chapter 7 page 77
Hope this helps
Regards Alex
Please rate useful posts
07-30-2014 11:33 AM
That did it. Thank you!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: