Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How do I create a monitor port on a SG200-26?

I have a Cisco SG200-26.  I'd like to connect a system running Wireshark to this and be able to see traffic.  In other switches I would have to configure this port as promiscuous or set this port to monitor other ports or in some way allow this port to see traffic destined for other ports.  How do I do this on a SG200-26?  I can't find any reference in the documentation nor was I able to turn up anything in a search here.

Thanks,

Dave

1 ACCEPTED SOLUTION

Accepted Solutions
Green

Hi Davehttp://www.cisco.com/c

Hi Dave

http://www.cisco.com/c/dam/en/us/td/docs/switches/lan/csbss/sf20x_sg20x/administration_guide/78-21139.pdf
Have a look at chapter 7 page 77

Hope this helps
Regards Alex

Please rate useful posts

Regards, Alex. Please rate useful posts.
2 REPLIES
Green

Hi Davehttp://www.cisco.com/c

Hi Dave

http://www.cisco.com/c/dam/en/us/td/docs/switches/lan/csbss/sf20x_sg20x/administration_guide/78-21139.pdf
Have a look at chapter 7 page 77

Hope this helps
Regards Alex

Please rate useful posts

Regards, Alex. Please rate useful posts.
New Member

That did it.  Thank you!

That did it.  Thank you!

1721
Views
0
Helpful
2
Replies