cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
547
Views
0
Helpful
2
Replies

How do I remove this line from my 6500?

jfraasch
Level 3
Level 3

spanning-treemode rapid-pvst
spanning-tree extend system-id
no spanning-tree vlan 200,210,220,230,240,250,300,310,320,330,340
spanning-tree vlan 1-2,100,110,120,130,140,150 priority 24576
spanning-tree vlan 200,210,220,230,240,250,300,310,320,330,340 priority 28672
diagnostic bootup level minimal
!

I don't want to have the second spanning-tree vlan line to show up at all.  They were added but we are changing and will not even have those VLANs on this switch.


I did the "no" command but it just added another annoying line of code.

Any suggestions?


James

1 Accepted Solution

Accepted Solutions

chaubcisco
Level 1
Level 1

Try this in config mode:

no spanning-tree vlan 200,210,220,230,240,250,300,310,320,330,340 priority 28672

spanning-tree vlan 200,210,220,230,240,250,300,310,320,330,340

That should do it.

View solution in original post

2 Replies 2

Reza Sharifi
Hall of Fame
Hall of Fame

James,

If you are not able to remove all with one command, then try removing them one at the time

HTH

Reza

chaubcisco
Level 1
Level 1

Try this in config mode:

no spanning-tree vlan 200,210,220,230,240,250,300,310,320,330,340 priority 28672

spanning-tree vlan 200,210,220,230,240,250,300,310,320,330,340

That should do it.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: