Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

How do I remove this line from my 6500?

spanning-treemode rapid-pvst
spanning-tree extend system-id
no spanning-tree vlan 200,210,220,230,240,250,300,310,320,330,340
spanning-tree vlan 1-2,100,110,120,130,140,150 priority 24576
spanning-tree vlan 200,210,220,230,240,250,300,310,320,330,340 priority 28672
diagnostic bootup level minimal
!

I don't want to have the second spanning-tree vlan line to show up at all.  They were added but we are changing and will not even have those VLANs on this switch.


I did the "no" command but it just added another annoying line of code.

Any suggestions?


James

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: How do I remove this line from my 6500?

Try this in config mode:

no spanning-tree vlan 200,210,220,230,240,250,300,310,320,330,340 priority 28672

spanning-tree vlan 200,210,220,230,240,250,300,310,320,330,340

That should do it.

2 REPLIES
VIP Super Bronze

Re: How do I remove this line from my 6500?

James,

If you are not able to remove all with one command, then try removing them one at the time

HTH

Reza

New Member

Re: How do I remove this line from my 6500?

Try this in config mode:

no spanning-tree vlan 200,210,220,230,240,250,300,310,320,330,340 priority 28672

spanning-tree vlan 200,210,220,230,240,250,300,310,320,330,340

That should do it.

398
Views
0
Helpful
2
Replies
CreatePlease to create content