I have a switch that is asking for a username and password and I already did a "no" on the login and password.. didn't seem to affect anything. Can someone tell me how to reset the vty parameters so I can telnet to the box. Thanks
The symptoms that you describe suggest that you have configured the switch with aaa new-model to support using an authentication server (perhaps ACS). When aaa new-model is configured the default on the vty becomes to prompt for username and password.
If it is the case that aaa new-model has been configured then there are at least 2 ways to resolve your issue. You can configure no aaa new-model and this will return the vty to their normal mode of operating and allow you to telnet. Or you can leave aaa new-model in place and then configure a login authentication that will include the vty and which will only use the line password, or will use no password at all.
If we knew what was already in your config and if we were more clear on what your requirements are (is it just telnet to vty, do you want the same actions on console as vty or different, do you want local authentication or authentication through an authentication server) we could give you better advice.
If you just want aaa new-model and to authenticate telnet with the line password then this should do:
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...