How do you reconfig an etherchannel from trunk mode on to desirable? have 2 6509's with an active etherchannel config'd using sup720 ports 5/1,5/2 and 6/1, 6/2. slot six is redundant card on both mls'.
Re: how do you sucessfully change 4 port etherchannel
Technically speaking, there should be no problem, since as a DTP rule a trunk can be established if one side is desirable and the other side is either Trunk, Desirable or Auto, accordingly i don't believe that there is going to be any service disruption.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...