How I can configure monitor session for that remote traffic using VLAN RSPAN and local traffic can be monitored in only one destination port?
I have two switches, one called SW_VIP_P20 and other SW_VIP_P5, in SW_VIP_20 is configured a VLAN RSPAN where arrives traffic of this switch to be passed through a trunk to SW_VIP_P5 which I must configure a monitor session with only one destination port for can ckeck the traffic that arrives through the trunk of VLAN RSPAN of SW_VIP_P20 and the traffic of some ports of SW_VIP_P5, is possible do it?
You may be able to have a destination port on source switch able to see the same traffic sent over the RSPAN vlan but not on the destination switch.(this is platform dependent should be possible on C6500, not effective on other switch models, I remember a thread about this in the forums).
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.