How many L2TPv3 tunnels can be supported by Cisco 1811 router?
I have several cisco 1811 routers at hand, and want to establish multiple L2TPv3 tunnels between them. The IOS is 12.4(15)T13.
But I find out the number of tunnels depend on the layer-3 ports. For a 1811 router, only two ports (FastEthernet 0 and 1) support the command "xconnect". Does it mean I can only establish at most 2 L2TPv3 tunnels on this router. But we need more tunnels. What should I do?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...