Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How Packets Filtering/Priority can be configure???

I have 4 Catalyst 2955 switches as Mesh Topology and running RSTP protocol.

I want to implement Traffic Prioritization...i.e. I want some packets/traffic from few special computers will get priority first from switches ...while other remainig computer's traffic/packets should be traeted with lower priority from switches.

How I can do this?

Shahid

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: How Packets Filtering/Priority can be configure???

You can configure qos in your 2955 switches, but you must be running EI image for this.

Use access control lists to mark the traffic from the special computers. After this you can use the suitable scheduling mechanism for more priority to these packets.

http://www.cisco.com/en/US/products/hw/switches/ps628/products_configuration_guide_chapter09186a00802c31e8.html

1 REPLY
Silver

Re: How Packets Filtering/Priority can be configure???

You can configure qos in your 2955 switches, but you must be running EI image for this.

Use access control lists to mark the traffic from the special computers. After this you can use the suitable scheduling mechanism for more priority to these packets.

http://www.cisco.com/en/US/products/hw/switches/ps628/products_configuration_guide_chapter09186a00802c31e8.html

113
Views
0
Helpful
1
Replies
CreatePlease login to create content