I have a uc560 with voip and data configured and 2 sf300 48Ports.
So, I tried to use VTP but the sf dont have support VTP. I know to send over trunk port, but over trunk port what kind of encapsulation will work ? And how can I use the same vlan tag over the 3 equips?
I wish set the vlan on uc560 and propagate on both sf300 based on port access. How can I use?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...