Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

how to apply policymap to vlan interface not n router interface

hi ,

i have a router that IS A GATEWAY for internet ,  and another router which is Bras which is used to connect to Dslam

my request is , i want to gurantee didicted cir for specific vlan which is vlan 10

im using subinterface connect to router gateway which is the gateway of my vlan 10.

the problem is , i cant use policymap on subinterface !!!!!!!! it is not allowed to use it, im using router ios 7206 .

so i began to think in another solution which is applying the polivy map on the interface Gi0/1 as u see from my gigure below ,

but the problem is , the cpu  takse high and rech up to 90 % , it consume 15 % after adding the polivy map >

i want a solution ,

could i use policy on the swithch ??? and consume the cpu on the other routers ???

is there any other optinal soultion to use QOS ?????

                                                            Bras router

                                                                   |   

                                                                   |

                                                                   |

                                                                   |

                    switch vlan 10  ===========routerGi0/1=============>internet

regards

Everyone's tags (6)
1 REPLY

how to apply policymap to vlan interface not n router interface

Ahmed M Alzaeem wrote:

hi ,

i have a router that IS A GATEWAY for internet ,  and another router which is Bras which is used to connect to Dslam

my request is , i want to gurantee didicted cir for specific vlan which is vlan 10

im using subinterface connect to router gateway which is the gateway of my vlan 10.

the problem is , i cant use policymap on subinterface !!!!!!!! it is not allowed to use it, im using router ios 7206 .

so i began to think in another solution which is applying the polivy map on the interface Gi0/1 as u see from my gigure below ,

but the problem is , the cpu  takse high and rech up to 90 % , it consume 15 % after adding the polivy map >

i want a solution ,

could i use policy on the swithch ??? and consume the cpu on the other routers ???

is there any other optinal soultion to use QOS ?????

                                                            Bras router

                                                                   |   

                                                                   |

                                                                   |

                                                                   |

                    switch vlan 10  ===========routerGi0/1=============>internet

regards

Hello ,

Check out the below link for policy map configuration

http://www.cisco.com/en/US/docs/interfaces_modules/services_modules/ace/v3.00_A1/configuration/administration/guide/mapolcy.pdf

Hope to Help !!

Ganesh

385
Views
0
Helpful
1
Replies
CreatePlease to create content