Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to avoid collision in Ethernet Port

I have 2950 router which connected to firewall through ethernet port. This ethernet port having lot of collision.. how to avoid these collisions..

1 REPLY

Re: How to avoid collision in Ethernet Port

Check your duplex settings in your interfaces, collisions will typically occur when one side is running at half duplex not full, if they cannot be negotiated via FLP.

HTH.

171
Views
0
Helpful
1
Replies