how to block the propagation of default route in packet tracer

[jpcapobianco]

hi i'm trying to block the propagation of the default route on one interface witch RIV2 in packet tracer.

i tried to uso the the ACCESS LIST command, but it blocks all the traffic if i use

WEST2(config)#access-list 1 deny 0.0.0.0  0.0.0.0

and then i go on the interface and i use

WEST2(config-if)#ip access-group  1

can i use other command to do this ?

something supported by packet tracer ?

[Peter Paluch]

Joseph,

See the following suggestion in the original thread you have opened:

https://supportforums.cisco.com/message/3989189#3989189

Usually, please allow for several hours for a reply to come to your thread - this is a voluntary forum and people devote their free time to answering questions - that's why it sometimes takes long for a person to respond.

Best regards,

Peter