Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

how to block the propagation of default route in packet tracer

hi i'm trying to block the propagation of the default route on one interface witch RIV2 in packet tracer.

i tried to uso the the ACCESS LIST command, but it blocks all the traffic if i use

WEST2(config)#access-list 1 deny 0.0.0.0  0.0.0.0

and then i go on the interface and i use

WEST2(config-if)#ip access-group  1

can i use other command to do this ?

something supported by packet tracer ?


1 REPLY
Cisco Employee

how to block the propagation of default route in packet tracer

Joseph,

See the following suggestion in the original thread you have opened:

https://supportforums.cisco.com/message/3989189#3989189

Usually, please allow for several hours for a reply to come to your thread - this is a voluntary forum and people devote their free time to answering questions - that's why it sometimes takes long for a person to respond.

Best regards,

Peter

771
Views
5
Helpful
1
Replies
CreatePlease to create content