02-16-2014 02:11 PM - edited 03-07-2019 06:14 PM
Ok, I have never been able to figure this out. I have a Cisco 2511 terminal server. Is there a way when using SecureCRT to bring up multiply devices going through the terminal server. What i keep doing is ctrl-shft-6-x but that's only going to be displayed on the same terminal window. I want to have multipe tabs open to the other devices. Other then putting a IP on all the devices and not using the terminal server while telneting I just can't seam to find a way. On videos like CBT nugget he goes through multipe tabs for his devices. I figued there has to be a way.
02-16-2014 02:56 PM
What version of SecureCRT do you have? I think, to open up multiple tabs you need version 6 or later.
HTH
02-16-2014 03:51 PM
I believe that this approach should work:
- open a session with SecureCRT.
- telnet to the term server.
- use the term server to open a console session to one device.
- open a new tab in SecureCRT.
- in the new tabl telnet to the term server.
- use the term server to open a console session to another device.
- open a new tab in SecureCRT.
- in the new tab telnet to the term server.
- use the term server to open a console session to another device.
This approach should work up to the max number of vty that are configured. By default that would be 5. You may be able to configure additional vty and if so you should be able to have additional sessions to additional devices.
HTH
Rick
02-16-2014 04:56 PM
Richard, are you able to telnet through the console port? I didn't think that was possible.
02-16-2014 05:56 PM
Do you think that I said to telnet through the console port? What in my suggestion has telnet and console port in the same line? Every time I suggest telnet it is through SecureCRT to the term server. And every time I mention console it is for the term server to open a session to the console port (which is what a term server does).
HTH
Rick
02-17-2014 05:32 AM
Yes that what I though you were implying. I dont know what port to telnet to the terminal server on. As you probably know, it has a console, aux, aui and 2 serial ports. What port am I telneting through on the terminal server?
02-17-2014 06:13 AM
Perhaps I should verify some assumptions that I made. How are you currently accessing the terminal server using SecureCRT? I was assuming that you were doing a telnet to the term server. But perhaps that is not the case.
HTH
Rick
02-17-2014 07:17 AM
This is for my home lab. I'm pluged from my laptop the the console port of the 2511 terminal server.
02-17-2014 08:12 AM
OK. That helps. My suggestion was based on the assumption that you had a network connection to the term server and that you were telnetting to the term server. If you are using a connection from your laptop to the console of the term server then I do not believe that there is an option where you can use multiple tabs and have multiple connections at the same time. I am sure that on things like CBT nugget they are using telnet sessions to the term server and that would allow you to use multiple tabs and have multiple connections at the same time.
HTH
Rick
02-17-2014 08:49 AM
Thanks Richard, so I guess there's no way possible to do what I want to do using a home lab.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide