How to cable/setup external network for redundancy
I have a pair of 2611XM routers, each with a different ISP. They are connected back to one 2950 switch. The switch is then uplinked back to a pair of ASAs. I want to add another 2950 in between. Right now I have a HSRP address on the inside interface of my routers. When adding the two more inside interfaces, I can just join them to my current HSPR group? Also, I wasn't sure on how to mesh between the ASAs and the 2950s...My outside interface is defined on one port, is there a way to 'bond' two ports together on the ASA? I'm also doing BGP on the external routers for ISP redundancy.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...