Is there any command or any configuration available in cisco device to check traffic summary in average.
i can check the traffic summary using sh int gig 1/0 summary this will display the total traffic and current utilization on that interface where WAN link was terminated.
I need to check the utilization for past 1 hrs or 2 hrs( Avergae ,low utilization and Peak utilization for those period). Please advice on it. U can suggest me any tool to monitor the same( Should be free ware).
Thanks in advance for ur solutions and suggestions...
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...