Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to check the traffic on Portchannel?

Hi All,

How to check the traffic (Past history and present traffic) on Port-channel in Cat 6500 Switch.

1. Total bytes per second (MBytes/Second)

2. Incoming bytes per second (KBytes/Second)

3. Outgoing bytes per second (KBytes/Second)

Thank you,

3 REPLIES

Re: How to check the traffic on Portchannel?

sh interfaces port-channel

Thanks,

Mohamad

New Member

Re: How to check the traffic on Portchannel?

Hi, here is the output of the command, it is not either giving me the Live traffic or past history on traffic(Ex: traffic on 22 MAr, 2008)

6513-01#show interfaces port-channel 1

Port-channel1 is up, line protocol is up (connected)

Hardware is EtherChannel, address is 0014.1cd8.35d1 (bia 0014.1cd8.35d0)

MTU 1500 bytes, BW 2000000 Kbit, DLY 10 usec,

reliability 255/255, txload 1/255, rxload 1/255

Encapsulation ARPA, loopback not set

Keepalive set (10 sec)

Full-duplex, 1000Mb/s

input flow-control is off, output flow-control is off

Members in this channel: Gi1/1 Gi1/2

ARP type: ARPA, ARP Timeout 04:00:00

Last input never, output never, output hang never

Last clearing of "show interface" counters 3d02h

Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0

Queueing strategy: fifo

Output queue: 0/40 (size/max)

5 minute input rate 5663000 bits/sec, 1117 packets/sec

5 minute output rate 5696000 bits/sec, 1025 packets/sec

272807444 packets input, 182711549047 bytes, 0 no buffer

Received 17386751 broadcasts (16630154 multicasts)

0 runts, 0 giants, 0 throttles

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored

0 watchdog, 0 multicast, 0 pause input

0 input packets with dribble condition detected

247353519 packets output, 181239696953 bytes, 0 underruns

0 output errors, 0 collisions, 0 interface resets

0 babbles, 0 late collision, 0 deferred

0 lost carrier, 0 no carrier, 0 PAUSE output

0 output buffer failures, 0 output buffers swapped out

Thank you,

Re: How to check the traffic on Portchannel?

This is somewhat live traffic:

5 minute input rate 5663000 bits/sec, 1117 packets/sec

5 minute output rate 5696000 bits/sec, 1025 packets/sec

We use Cacti for monitoring traffic history. I don't think there is a way to monitor past traffic on a switch.

360
Views
5
Helpful
3
Replies
CreatePlease to create content