How to configure a port channel with VLAN trunking (and make it work..)
We're trying to configure a port channel group with trunked ports to connect a NetApp HA pair. We want to create two data LIFs and connect them to the switch stack. We are trying to create 2 data lifs, one for cifs and one for nfs that are on different vlans.
We want the same ports to be able to allow multiple vlans to communicate. (trunked)
These data lifs should be able to fail over to different nodes in the HA pair and still be able to communicate on the network.
What this means is that we have to connect 4 ports each for each node in the NetApp HA Pair to the switches and create a port channel of some type that allows for trunked vlans. When we configure the ports, the configuration is as follows (below):
We are only able to configure an IP on one of the vlans.
When we configure an IP from another vlan for the data lif, it does not respond to a ping.
Does anyone have any idea what I'm doing wrong on the Cisco switch?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.