12-10-2009 05:27 AM - edited 03-06-2019 08:54 AM
hello all,
How to configure the automatic failover between two connection (access) internet in cisco routeur 2800 serie?
Best Regards,
Solved! Go to Solution.
12-10-2009 05:51 AM
Hi,
If you have 2 internet connections terminating on 2800 router, you can simply configure 2 default static route pointing to next hop and have load balance the traffic to Internet.
or, you can configure 2 default static route, one with default Administrative Distance (Your Primary ISP) and other with higher Administrative Distance (Secondary ISP) as below,
ip route 0.0.0.0 0.0.0.0
ip route 0.0.0.0 0.0.0.0
HTH,
Nagendra
12-10-2009 05:51 AM
Hi,
If you have 2 internet connections terminating on 2800 router, you can simply configure 2 default static route pointing to next hop and have load balance the traffic to Internet.
or, you can configure 2 default static route, one with default Administrative Distance (Your Primary ISP) and other with higher Administrative Distance (Secondary ISP) as below,
ip route 0.0.0.0 0.0.0.0
ip route 0.0.0.0 0.0.0.0
HTH,
Nagendra
12-10-2009 06:43 AM
thanks naikumar,
How can i load balance the traffic to Internet ?
Best Regards,
12-10-2009 08:32 AM
Hi,
Configure 2 default static route without changing the administrative distance. Router will install both the default route in table and will perform load balancing.
HTH,
Nagendra
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide