Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to configure automatic failover between two connection (access) internet in cisco routeur 2800 serie?

hello all,

How to configure the automatic failover between two connection (access) internet in cisco routeur 2800 serie?

Best Regards,

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: How to configure automatic failover between two connection (

Hi,

If you have 2 internet connections terminating on 2800 router, you can simply configure 2 default static route pointing to next hop and have load balance the traffic to Internet.

or, you can configure 2 default static route, one with default Administrative Distance (Your Primary ISP) and other with higher Administrative Distance (Secondary ISP) as below,

ip route 0.0.0.0 0.0.0.0

ip route 0.0.0.0 0.0.0.0 254

HTH,

Nagendra

3 REPLIES
Cisco Employee

Re: How to configure automatic failover between two connection (

Hi,

If you have 2 internet connections terminating on 2800 router, you can simply configure 2 default static route pointing to next hop and have load balance the traffic to Internet.

or, you can configure 2 default static route, one with default Administrative Distance (Your Primary ISP) and other with higher Administrative Distance (Secondary ISP) as below,

ip route 0.0.0.0 0.0.0.0

ip route 0.0.0.0 0.0.0.0 254

HTH,

Nagendra

New Member

Re: How to configure automatic failover between two connection (

thanks naikumar,

How can i load balance the traffic to Internet ?

Best Regards,

Cisco Employee

Re: How to configure automatic failover between two connection (

Hi,

Configure 2 default static route without changing the administrative distance. Router will install both the default route in table and will perform load balancing.

HTH,

Nagendra

3157
Views
0
Helpful
3
Replies
CreatePlease to create content