How to configure EIGRP in VLAN using Multilayer switches?
I have configured 2 Multilayer switches (in two buildings) connected to a router. I have configured VLAN, NAT, access-list and default route. I am able to ping internet and the router and the internet (Default Route), but I cannot ping the other layer switch in other building. I tried to configure EIGRP on the switches and the router, but I am still unable to ping the computers in the other building. When I configured the EIGRP I did not get any discovery message!
I have attached an image of my topology I am using. I basically have 1 router connected to both switches and internet. Switches are in separate buildings and have VLANs, NAT, default route configured.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.