Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to configure Etherchannel(LACP)?

Provide step by step how to configure Etherchannel(LACP)

5 REPLIES

Re: How to configure Etherchannel(LACP)?

Hi

First make sure that the ports u want to use in the etherchannel are having indentical configs and after that.

for eg.

switch#conf t

switch(config)#interface range f0/1 - 2

switch(config-if)#switch port mode trunk

switch(config-if)#switchport truk encap dot1q

switch(config-if)#channel-group 1 mode active

this should be done on both the switches.

Thanks

Mahmood

Re: How to configure Etherchannel(LACP)?

there's a missing config line to be added here:

Switch(config-if)#channel-protocol lacp

Purple

Re: How to configure Etherchannel(LACP)?

The channel protocol lacp is not absolutely needed it knows when you add channel-group x mode active that it is lacp . I don't know why they have that separate command , maybe someone else can chime in why thats even there .

Hall of Fame Super Silver

Re: How to configure Etherchannel(LACP)?

Hello Vinoth,

here is a reference to chapter on config guide for c3750

http://www.cisco.com/en/US/docs/switches/lan/catalyst3750/software/release/12.2_44_se/configuration/guide/swethchl.html#wp1275881

I recommend if you need a trunk to provide an explicit list of needed vlans on the trunk with

switchport enc dot1q

swichport mode trunk

switchport trunk allowed vlan x,y,z-k,w

the same list has to be configured on both ends and on every member link.

John:

Actually in newer releases the command to specify the protocol used looks like not necessary anymore for example in the document I've linked.

However, it shouldn't hurt and I agree it is necessary on older versions of code

Hope to help

Giuseppe

New Member

Re: How to configure Etherchannel(LACP)?

Ok guys this is the simply explanation.

Pagp is Cisco proprietary. Port aggregation Protocol

Lacp is industry standard. Link aggregation protocol.

to enable PAGP

Go to the interfaces say i decide to group two interfaces together

Int range fa0/1 - 2

channel-group 1 mode ? (auto or desirable)

channel protocol pagp (Technically this command is not needed because the switch knows immediatelly from the previous command you are using Cisco PAGP protocol that has only auto or desirable)

to enable LACP

Int range fa0/1 - 2

channel-group 1 mode ? (active or passive)

channel protocol LACP (Technically this command is not needed because the switch knows immediately from the previous command you are using Cisco LACP protocol that has only active or passive)

Now I personally stay away from anything auto (If you want something done do it Hard code the thing). Personal choice. Alright auto on somethings are good at times.

Int range fa0/1 - 2

channel-group 1 mode on

Rules.

All ports must have identical configurations.

example.

Int range fa0/1 - 2

duplex full

speed 100

trunk or access ports

Now am sure we know that the opposite side must be configured the same way. For LACP Passive, active will form channel. You guessed it desirable and on will work not the other way round.

Pls Rate if this helps.

913
Views
20
Helpful
5
Replies
CreatePlease to create content