Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

how to configure load balance in static route?

how to configure load balance in static route?

4 REPLIES

Re: how to configure load balance in static route?

ip route <> <> <>

ip route <> <> <>

eg

ip route 172.16.1.0 255.255.255.0 172.16.1.254

ip route 172.16.1.0 255.255.255.0 172.16.254.254

or

ip route 192.168.1.0 255.255.255.0 e1

ip route 192.168.1.0 255.255.255.0 e2

HTH>

New Member

Re: how to configure load balance in static route?

How load balance work in default routing??/

Re: how to configure load balance in static route?

Using static load balancing, you can configure traffic load balancing on a per-packet basis without using a dynamic routing protocol. Most routers will perform load balancing automatically if several equal cost paths to a destination exist on multiple interfaces. To configure this using static routing, you need only create multiple static routes for more than one interface. This creates more than one equal cost path which will balance the load.

Cisco routers perform load balancing on a per-destination, per-source-destination and per-packet basis. Load can be balanced across up to six equal cost paths.

HTH>

196
Views
0
Helpful
4
Replies
CreatePlease to create content