How to configure monitoring access to a device on a private vlan?
I have a large network which consists of a private and public IP block. I'm attempting to do something a little different. At a given location I have set up two wireless point to point links. These wireless links act as a bridge passing "any" traffic. The IP addresses of the devices are/would be visible on my management private IP block (10.1.0.0/16). The purpose of the wireless link is to provide a 20meg circuit between two endpoints for a customer. So I have four wireless radios set up which span the 5 mile links. My problem is this, how can I keep traffic from this customer (presumably using a 10/172/192 class a/b/c private ip block) on a separate broadcast domain and yet monitor/graph the radios? Is it possible using only vlan's and access lists or am I going to need a router? In other words, I want to monitor the radios health and traffic bandwidth from my side and yet keep their network traffic within the circuit (or vlan) isolated. Sadly, this would all be very easy if the radios had a separate management port rather than inband management. Any suggestions would be very much appreciated.
What I have so far. Of course, with the two ports 10 and 11 on a separate vlan (500), the 10.1.254.1-4 ip's are no longer visible to my network as expected.
my network (native vlan1 and vlan2) on a Catalyst 2900XL
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.