Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

How to configure port monitoring (SPAN) on a CRS-8/S device ?

Need to setup sniffer to capture a L3 port..Is there any equivalent command on CRS-8/S as 65xx can use monitor session xx to do...?

I know in 65Xx switch there is monitor session command available...

For example..

MUMMCVS08w02 (Config)# monitor session 1 source interface Gi1/18 ( The interface need to plug in sniffer )

MUMMCVS08w02 (Config)# monitor session 1 destination interface Gi1/44

Partial show version as below..

                  

Cisco IOS XR Software, Version 3.8.4[00]
Copyright (c) 2010 by Cisco Systems, Inc.

ROM: System Bootstrap, Version 1.54(20091016:214209) [CRS-1 ROMMON], 

CNHKGXXXXXXXX uptime is 18 weeks, 1 day, 5 hours, 37 minutes
System image file is "bootflash:disk0/hfr-os-mbi-3.8.4/mbihfr-rp.vm"

cisco CRS-8/S (7457) processor with 4194304K bytes of memory.

Everyone's tags (2)
1 REPLY
Hall of Fame Super Silver

How to configure port monitoring (SPAN) on a CRS-8/S device ?

Hello Vincent,

CRS has no SPAN capabilities, according to some threads in the forums the only IOS XR device with SPAN capabilities should be ASR 9000.

I'm sorry to give you bad news

Hope to help

Giuseppe

684
Views
0
Helpful
1
Replies
CreatePlease to create content