Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to configure rate-limit input & rate-limit output command under SVI's in Cisco 4500X

I want to configure rate-limit command under SVI's created in 4500X,  but when I try to run this command it doesn't support this.Can anyone help me and letting me know how can I configure the rate-limit command under SVI's

Many Many Thanks for help.

4 REPLIES
Silver

How to configure rate-limit input & rate-limit output command un

Rate-limit (CAR) was the old way of doing policing. Check the configuration guide here for 4500:

http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/15.02SG/configuration/guide/qos.html#wp1437716

You can do either shaping or policing, guaranteeing bandwidths to different classes and so on.

Daniel Dib
CCIE #37149

Daniel Dib CCIE #37149 Please rate helpful posts.
New Member

How to configure rate-limit input & rate-limit output command un

Thanks Daniel , but Can we configure Rate-Limit in 4500X ? or we have to configure classes & policy map for the same

Silver

How to configure rate-limit input & rate-limit output command un

I don't think this command is available any longer, at least I couldn't find it in the command reference. You need to start using the new tools for QoS.

Daniel Dib
CCIE #37149

Daniel Dib CCIE #37149 Please rate helpful posts.
New Member

Re: How to configure rate-limit input & rate-limit output comman

Thanks Daniel, how shall I configure the below command with shape average command in 4500X ? I have created the configs below , can you please confirm if its correct ?

Old Way

rate-limit input 4096000 768000 1536000 conform-action transmit exceed-action drop

rate-limit output 4096000 768000 1536000 conform-action transmit exceed-action drop

New WAY

4500X# configure terminal

4500X(config)# policy-map policy1

4500X(config-pmap)# class 4MB

4500X(config-pmap-c)# shape average 4096000

4500X(config-pmap-c)# exit

4500X(config-pmap)# exit

4500X(config)# interface vlan 30

4500X(config-if)# service-policy output policy1

4500X(config-if)# service-policy input policy1

6037
Views
0
Helpful
4
Replies