Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to configure supervisory disconnect in 5300

I have 2 sites, one site is a 3640 to PSTN via FXO, the other site is a 5300 to a switch. I use Connetion PLAR to connect 2 sites via internet. The IOS in 3640 is IOS (tm) 3600 Software (C3640-JS-M), Version 12.2(31), RELEASE SOFTWARE (fc2), in 5300 is IOS (tm) 5300 Software (C5300-JS-M), Version 12.3(6), RELEASE SOFTWARE (fc3). My problem is sometimes when users finished a call, the call did not hang up in the switch, especially when there is no one answer at the switch side, this call will be busy for a long time in the switch. Is there any configuration in the 5300, like a FXO supervisory disconnect, to inform the switch when the call has been hung up. But I do not have this problem with this 5300 with other voice traffic, like the traffic from another 5300.

2 REPLIES
Silver

Re: How to configure supervisory disconnect in 5300

If the FXO Supervisory Disconnect Tone feature is configured and a detectable tone from the PSTN or PBX is

detected by the digital signal processor (DSP), the analog FXO port goes on-hook. You can configure the router's FXO voice port to detect supervisory disconnect tones before the audio path is established (before the call is answered).

New Member

Re: How to configure supervisory disconnect in 5300

Thanks.

Yes, I have configured FXO to detect supervisory disconnect as follows:

!

voice class dualtone 90

freq-pair 1 350 440

freq-pair 2 480 850

freq-pair 3 1000 1250

!

!

voice-port 1/0/0

supervisory disconnect dualtone mid-call voice-class 90

timeouts call-disconnect 5

timeouts wait-release 5

connection plar 6262336898

!

voice-port 1/0/1

supervisory disconnect dualtone mid-call voice-class 90

timeouts call-disconnect 5

timeouts wait-release 5

connection plar 6262336898

!

But I am not sure this configuration is correct, since this 3640 is in Ecuador, I can not find the cptone or detailed information for this country.

And is this enough? Nothing at 5300 side?

Thanks a lot.

165
Views
3
Helpful
2
Replies