how to configure trunking or etherchannel on sg200-26p gigabit p
The Trunk Encapsulation Dot1Q command only exists on switches which are still capable of using the ISL tagging method. If the command is not available, then it means the switch only supports dot1q and this is the default on a trunk.
Apologies if I have misread your question but it is fairly vague.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...