How to copy a config file to new 3560series switches???
I'm in the process of swapping out switches. I'm removing a 2950 series & replacing it with a 3560 series.I have saved the startup-configuration of the 2950series to a TFTP server(My PC). I want to copy this configuration file to the 3560series. I'm connected to the new 3560series switch via the console port. How do I copy this configuration file from my PC(TFTP server) to the new 3560series switch via the console port?
Re: How to copy a config file to new 3560series switches???
A quicker and maybe an easy way would be to assign a temp IP to the switch and assign your TFTP server an IP address in the same subnet and then copy that config file using tftp rather x-modem because it takes a longer time.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...