Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

How to create stack with two 3750G switches

Hi,

I need to create a switch stack with two 3750G switches. What's the best way to do this?

Thanks

2 REPLIES
Community Member

Re: How to create stack with two 3750G switches

Hi

The stacking configuration done automatically when you are connect the stack cable back side of the switch

the connection will be like this

switch 1  stack port 1  need to connnect switch 2 stack port 2

the same vise versa switch 1 stack port 2  need connect switch 2 stack port 1

If you want one switch always act as a master you can set the priority to the switch

conf t

switch 1  priority  5 ( you can set any number  should be highest number in the stacked switches )

regards

krishna kumar

VIP Super Bronze

Re: How to create stack with two 3750G switches

Hello Darren,

After stacking them, decide witch switch you want to be the master and give that one a higher priority.  The priority is from 1 to 15 with 15 being the highest.

Also make sure you run the same exact IOS on both switches.

Please refer to this document for more info:

http://www.cisco.com/en/US/docs/switches/lan/catalyst3750/software/release/12.2_50_se/configuration/guide/swstack.html

HTH

Reza

521
Views
0
Helpful
2
Replies
CreatePlease to create content