Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

how to create user in 2825 router? ****ASAP****

dear all,

I want to configure a new user on 2825 router.

my requirements are as follows:

user name : user121

password : user121

access : privileged level

commands : sh commands only

thanks in advance

fani

1 REPLY

Re: how to create user in 2825 router? ****ASAP****

Hi,

Simply do the following:

username test privilege 5 password test

privilege exec all level 5 show

line vty 0 4

login local

But please note that, when access to the router is configured by privilege levels, a common issue is that the show running is configured at or below the user's privilege level. When the user executes the command, the configuration appears to be blank. This is actually by design due to that this command displays all of the commands that the current user is able to modify (in other words, all the commands at or below the user's current privilege level). The command should not display commands above the user's current privilege level because of security considerations. If so, commands such as snmp-server community could be used to modify the current configuration of the router and gain complete access to the router.

For example, if a certain privilege level is given the privilege to configure under the interface, and do show run, when a user do show run with this level, he will get only the interface configurations:

privilege configure all level 5 interface

privilege exec all level 5 show running-config

Router#sh run

Building configuration...

Current configuration : 1055 bytes

!

boot-start-marker

boot-end-marker

!

!

!

!

!

interface Loopback0

ip address 10.10.10.2 255.255.255.255

!

interface Serial1/1

no ip address

shutdown

!

end

HTH, please do rate all helpful replies,

Mohammed Mahmoud.

168
Views
3
Helpful
1
Replies
CreatePlease to create content