Hi I am newbie here. I am hoping someone to please help me for setting up the VLAN's in my Cisco SF-302-08P. I already configured this switch in L3 mode and I already created the VLAN2 and assigned the port to VLAN which are GE1 and GE2 untagged.
However, If I would create in IP Configuration--------IPV4 Interface and I add the VLAN2 and setup the IP Address 192.168.2.254 with Mask 255.255.255.0, After I click the apply button, It looks like nothing..just loading and I noticed that stopped not pinging the default VLAN1 which is 192.168.1.254.
I tried to power off the switch again..after loading I can access again the GUI but still no luck to create or configure an IP address for the VLAN2. I used this version of firmware sx300_fw-14502.ros and also I tried to downgrade to Sx300_FW-220.127.116.11 but I have no luck still the same issue I encountered.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...