Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How To Disable PoE feature on a individual switch port

Hi,

I have a PoE enabled device connected to our 2960-S switch port Gi 2/0/45 for which I am getting following log continuously.

184581: 045866: Jul 18 09:22:06.305 MUM: %ILPOWER-7-DETECT: Interface Gi2/0/45: Power Device detected: IEEE PD (D_USER_STACK-2-2)
184582: 045867: Jul 18 09:22:07.469 MUM: %ILPOWER-5-IEEE_DISCONNECT: Interface Gi2/0/45: PD removed (D_USER_STACK-2-2)
184583: Jul 18 09:22:08.513 MUM: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet2/0/45, changed state to down
184584: Jul 18 09:22:09.530 MUM: %LINK-3-UPDOWN: Interface GigabitEthernet2/0/45, changed state to down
184585: Jul 18 09:22:10.830 MUM: %PARSER-5-CFGLOG_LOGGEDCMD: User:mman  logged command:!exec: enable
184586: Jul 18 09:22:11.790 MUM: %LINK-3-UPDOWN: Interface GigabitEthernet2/0/45, changed state to up
184587: Jul 18 09:22:12.791 MUM: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet2/0/45, changed state to up

This is causing the port to flap continuously.

The device is working on the required ac power supply which can not be removed as device gets powered off completely.

So disabling the PoE capability on the port may solve the issue.

Kindly suggest the steps/commands or any other solution to solve this issue.

Regards.

 

3 REPLIES

HelloInt xxpower-inne never

Hello

Int xx

power-inline never

 

Res Paul

Please don't forget to rate any posts that have been helpful. Thanks.
New Member

Hi Paul,I did what u

Hi Paul,

I did what u suggested...and it has worked for me....the port flapping has stopped now.

For knowledge purpose can u explain what is exactly happening here...how does this PoE works and what exactly causing issue?

Regards. 

Hall of Fame Super Gold

Let's do the basics first ...

Let's do the basics first ... 

 

Do the following: 

 

1.  Command:  test cable tdr interface Gi2/0/45;

2.  Wait for approximately 5 seconds; 

3.  Command:  sh cable tdr interface Gi2/0/45; and

4.  Post the output to #3.

691
Views
5
Helpful
3
Replies
CreatePlease login to create content