Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to elect SUP module as a active by manual configuration.

Hi, all.

I am struggling that if SUP engine can be configured as a active with manual configuration.

If I equipped two engines, SUP automatically decide to elect a active module. But I want to know which slot is higher between two slots.

And how can i control one SUP is active and other SUP is standby.

Thanks

1 REPLY

Re: How to elect SUP module as a active by manual configuration.

I don't believe there is a way to configure a specific supervisor to be "active" when the switch boots up. When the switch boots up whichever supervisor boots first typically will be the active supervisor.

HTH,

Mark

100
Views
0
Helpful
1
Replies