Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

How to Enable a port after err-disable

Hello

I had a port get disabled because of a feedback loop. Plugged it back Iin and cannot re-enabled via CNA

Is there a command to re-enable the port

The document i found suggest using the shut down then no shut down command

Is that safe ? will it kick all ports ?

Cisco Catalyst 3750

Thanks

2 ACCEPTED SOLUTIONS

Accepted Solutions
VIP Super Bronze

Re: How to Enable a port after err-disable

Hi

Yes, Just do a sh and no sh on that port.  That should enable the port again.

HTH

Reza

New Member

Re: How to Enable a port after err-disable

Hi,

We can use 'shut' , 'no shut' and we can configure the switch to recover automatically.

Commands are as follows:

errdisable detect cause command 2-140

errdisable detect cause small-frame comand 2-143

errdisable recovery cause small-frame 2-145

errdisable recovery command 2-146

error conditions, displaying 2-469

more details of the commands link:

http://www.cisco.com/en/US/docs/switches/lan/catalyst3750/software/release/12.2_44_se/command/reference/ComRef.html#LTR_E

Hope this helps!

Regards,

podhillo

2 REPLIES
VIP Super Bronze

Re: How to Enable a port after err-disable

Hi

Yes, Just do a sh and no sh on that port.  That should enable the port again.

HTH

Reza

New Member

Re: How to Enable a port after err-disable

Hi,

We can use 'shut' , 'no shut' and we can configure the switch to recover automatically.

Commands are as follows:

errdisable detect cause command 2-140

errdisable detect cause small-frame comand 2-143

errdisable recovery cause small-frame 2-145

errdisable recovery command 2-146

error conditions, displaying 2-469

more details of the commands link:

http://www.cisco.com/en/US/docs/switches/lan/catalyst3750/software/release/12.2_44_se/command/reference/ComRef.html#LTR_E

Hope this helps!

Regards,

podhillo

469
Views
0
Helpful
2
Replies
CreatePlease to create content