Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to exit the 2511 session?

Hi All,

We have a 2511 terminal server. When I console into 2511 and then telnet to the different port, I'm able to use "CTRL+SHIFT+6" plus "x" to exit current session. But when I telnet 2511 with specified port from the desktop on the network, the exit "CTRL+SHIFT+6" plus "x"doesn't work anymore. Do I need configure the vty in 2511 something special to make this work? Thanks.

Lou

2 REPLIES
VIP Super Bronze

Re: How to exit the 2511 session?

Hi Lou,

When you telnet from your PC to the 2511, "CTRL+SHIFT+6" plus "x" does not work.  You exit by just typing "q" and enter. "CTRL+SHIFT+6" plus "x" is for jumping around from one device to another when you are at the 2511 just like the first scenario you described.

HTH

Reza

New Member

Re: How to exit the 2511 session?

Thanks Reza. When I hit q and enter, it just exit from the device session. If I hit enter again, it just goes back to that device. I usually enter exit to totally exit from the telnet window. But right now the exit only exit the privilage mode. I'm still in that device.

Lou

522
Views
0
Helpful
2
Replies