Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to find out loop in my network..

I suspect loop in my network . How to find out loop in my network. Is there any log file available ..

1 REPLY

Re: How to find out loop in my network..

Vinoth,

Things you may want to first look into is access switch logs and core switches logs if any, look for flapping interfaces specially if you have dual uplink connections to a dual core switches, go over these links bellow

show log

show process cpu <-- flapping interfaces and/or bridging loops will also cause high cpu utilization, more details in bellow link.

See Identify the loop section in STP link

Troubleshooting STP

http://cisco.com/en/US/tech/tk389/tk621/technologies_tech_note09186a0080136673.shtml

If you have an HSRP environment on your core switches and happened to see HSRP SSTANDBY-3-DUPADDR message logs most of time is due to STP configuration issues, this link will give you a more thorough perspective on these type of messages.

Troubleshooting HSRP Problems - STP

http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a0080094afd.shtml

Rgds

-Jorge

PLS rate any helpful post if it does!

17801
Views
4
Helpful
1
Replies