to find out which switchports re unused I had a look with "show int" to the counters where nearly all interfaces shows " Last input never..." which should indicate that there never bidirectional traffic had been seen on this port?
I found this on different plattforms and versions where are active clients connected...
Show interface status will only show you if someone is not powered to the port at that particular time , doesn't tell you if someone was powered up yesterday on it or not . The only piece of gear that I have seen that will give you this info is the 4500 series switches where the command "show interface link" will show you when the port was last powered up . This command should be available on all cisco gear because it seems to be a requirement that a lot of people would like to see.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.