Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to identify MDI/MDIX status of the Gig port on the c7600, 12.2.33 SRA2

Hello,

We have c7600 running IOS 12.2.33 SRA2. I am looking for the way how to identify MDI/MDIX status of the GigabiEthernet port. I am not able to use "show controller GigabiEthernet" command in this IOS release.

thanks in advance,

jm.,

2 REPLIES
Silver

Re: How to identify MDI/MDIX status of the Gig port on the c7600

When you enable Auto-MDIX, you must also set the speed and duplex on the interface to auto in order for the feature to operate correctly. Auto-MDIX is supported on all 10/100 and 10/100/1000 Mbps interfaces. It is not supported on the SFP module.

interfaces.

Try:

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat2940/12122ea5/2940scg/swint.htm#wp1152934

New Member

Re: How to identify MDI/MDIX status of the Gig port on the c7600

OK, auto-MDIX feature is working without any problem, but the question is: "How is it possible to identify the state of the Auto-MDI/MDIX feature for 10/100/1000 Mbps ethernet port, is there a Cross-over cable used between devices or Straight-Through cable? - on c7600 running 12.2(33)SRA3 IOS"

For example, command available in this IOS release "show interfaces gigabitEthernet 3/1 controller" doesn't report anything about Auto-MDIX state of the port.

Thanks

jm.,

604
Views
0
Helpful
2
Replies