Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to limit ingress bandwidth on a Catalyst 2960

Hi

I would like limit the ingress bandwidth of interface on a switch.

In the doc (2960 Config Guide for IOS 12.2(44)SE page 31-67), I found this command :

srr bandwidth limit X (with X between 10-90)

This work very well for egress traffic.

For a PC connected to the switch port, this command limit the download for the PC.

Because on the switch I have some Internet Web site, most of the traffic is ingress traffic (for the switch port) and I would like to control the bandwidth usage. For the server connected to the switch, most traffic is upload.

For example on a 100 Mbits port, I want to limit the bandwidth (so I want to limit the upload) to 13 Mbits/s

How can I do that ?

Regards

1 REPLY

Re: How to limit ingress bandwidth on a Catalyst 2960

Hi aamsaleq,

Have you thought about using QOS. This is the best way to achieve proper prioritiy of traffic.

Regards,

Justin

721
Views
0
Helpful
1
Replies