Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

how to make a route feasible successor

Hi all, I have 2 switches connected , by 2 different l3 interfaces, so they are both successors and load balancing, how would I make one of the routes to become feasible successor? the interfaces are normal fastethernet.

cheers

Carl

3 REPLIES
Hall of Fame Super Silver

Re: how to make a route feasible successor

Hello Carl,

if you want to make one link less preferred then the other one

check current delay with

sh int fx/y

then use

int fx/y

delay xxx

use a greater value then the default one.

method2:

more selective using offset-list applied under router eigrp process

http://www.cisco.com/en/US/docs/ios/iproute/configuration/guide/irp_cfg_eigrp_ps6350_TSD_Products_Configuration_Guide_Chapter.html#wp1054179

using this you can make one path less preferred only for specific route(s)

Hope to help

Giuseppe

New Member

Re: how to make a route feasible successor

how would I make it feasible successor? i changed the delay to higher, but its still showing as successor.

any ideas ?

Hall of Fame Super Silver

Re: how to make a route feasible successor

Hello Carl,

may you post

sh ip eigrp topology

! let me use placeholders names for the

! two lan interfaces

sh int f0/0

sh int f0/1

sh ip eigrp int f0/0

sh ip eigrp int f0/1

all of these commands on the local router that sees the two equal cost paths

Hope to help

Giuseppe

192
Views
0
Helpful
3
Replies