Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k

How to remove encapulation slip on 3800 device on async interface

How to remove encapulation slip on 3800 device on async interface

2 REPLIES

Re: How to remove encapulation slip on 3800 device on async inte

The below is my config on my device. when i do no encapulation slip. i get no error message. but if i verify the config again. it still remains . I appreciate your help. Thanks.

interface Async0/2/0

no ip address

encapsulation slip

VIP Super Bronze

Re: How to remove encapulation slip on 3800 device on async inte

vimal.networkengineer wrote:

The below is my config on my device. when i do no encapulation slip. i get no error message. but if i verify the config again. it still remains . I appreciate your help. Thanks.

interface Async0/2/0

no ip address

encapsulation slip

Hello,

For Async interfaces Slip is the default encapsulation.  If you want to change it to another type, you can for example type "enacp ppp"

HTH

Reza

192
Views
0
Helpful
2
Replies
CreatePlease to create content